Caterpillar Factory passwords are required in order to perform the following functions in the Caterpillar Electronic Technician (ET): Change the system configuration parameters when the Engine Control Module (ECM) is replaced, the...

Features:

- 10 digits only

- Two version (VMware and non-virtual machine)

- CAT Factory PW generator (10 Digit Password only)

- working with all caterpillar construction Machines, Trucks, Engines ..... etc

- support Win7 Win8 Win10 and Win11

- working with ET 2019/2020/2021/2022/2023

- covering ALL REASONS for password generation .

- CAN INSTALL ON Unlimited PC, can be used on multiple PC computers

Caterpillar Factory passwords are required in order to perform the following functions in the Caterpillar Electronic Technician (ET):

Change the system configuration parameters
When the Engine Control Module (ECM) is replaced, the system configuration parameters must be programmed into the new ECM. A new ECM will allow these parameters to be programmed once without factory passwords. After the initial programming, factory passwords are required to program the parameters.

Rerating the engine to another engine family
This includes flash programming an ECM from a non-multitorque flash file to a multitorque flash file.

Read customer passwords
Factory passwords are required in order to read the customer passwords.

Clear certain diagnostic trouble codes
Certain codes require a factory password in order to clear the code. A 3473-31 (J1939) Aftertreatment Failed to Ignite code is one example.

Unlock a customer specified parameter that is locked
If a customer specified parameter has been locked out, factor